Nicht lieferbar
Andere Kunden interessierten sich auch für
![Fuel Composition Analysis of Endothermically Heated Jp-8 Fuel for Use in a Pulse Detonation Engine]( "Fuel Composition Analysis of Endothermically Heated Jp-8 Fuel for Use in a Pulse Detonation Engine")
Fuel Composition Analysis of Endothermically Heated Jp-8 Fuel for Use in a Pulse Detonation Engine52,99 €![Back-Pressure Effect on Shock-Train Location in a Scramjet Engine Isolator]( "Back-Pressure Effect on Shock-Train Location in a Scramjet Engine Isolator")
Back-Pressure Effect on Shock-Train Location in a Scramjet Engine Isolator52,99 €![Vacuum Ultraviolet Absorption Measurements of Atomic Oxygen in a Shock Tube]( "Vacuum Ultraviolet Absorption Measurements of Atomic Oxygen in a Shock Tube")
Vacuum Ultraviolet Absorption Measurements of Atomic Oxygen in a Shock Tube52,99 €![Operational Characteristics of a Rotating Detonation Engine Using Hydrogen and Air]( "Operational Characteristics of a Rotating Detonation Engine Using Hydrogen and Air")
Operational Characteristics of a Rotating Detonation Engine Using Hydrogen and Air52,99 €![Detonation Propagation Through Ducts in a Pulsed Detonation Engine]( "Detonation Propagation Through Ducts in a Pulsed Detonation Engine")
Detonation Propagation Through Ducts in a Pulsed Detonation Engine52,99 €
Shock tubes utilize a difference in pressures between gases separated by a diaphragm to create a shock wave when the diaphragm ruptures. By using sensors of known spacing, the speed of the wave can be determined. The AFIT 2-inch shock tube was reassembled and tested to ensure proper and safe operation. A high-speed data acquisition system was configured to take data at 2 MS/s. This research showed that the Mach number of the shock waves produced in this shock tube fall within 7% of theoretical values at speeds under Mach 3 and within 9% at higher speeds. The peak velocity of each shock wave was shown to occur at approximately 3 meters from the diaphragm.